All-Wheel Drive Pump -V415-, REMOVING AND INSTALLING, 0D3 AND 0BX: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- The hydraulic pump -A- is installed inside the hydraulic control unit. Assembling the hydraulic pump. Refer to Figure.
- The adapter -B- is installed in the recesses in the hydraulic pump.
- A new O-ring -D- is on the All-Wheel Drive Pump -V415-.
-- Insert the All-Wheel Drive Pump -V415- with the coupling -C- into the adapter -B-.
-- Diagonally tighten the four bolts on the All-Wheel Drive Pump -V415- -2- to the tightening specification ) OVERVIEW - HYDRAULIC CONTROL UNIT 0D3 AND 0BX.
-- Connect the connector -1- to the All-Wheel Drive Pump -V415-.
-- Fill the ATF in the rear final drive. Refer to ATF, FILLING, 0D3 AND 0BX "quattro sport" .