Control Module, Removing And Installing: Notes

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

The following are integrated in the All-Wheel Drive Control Module -J492- -1- :

Fig 1: Identifying All Wheel Drive Control Module -J492- -1-

GWWA39-10890

Courtesy of AUDI OF AMERICA, LLC

All-Wheel Drive Clutch Actuator -V622-
All-Wheel Drive Clutch Position Sensor -G969-

Replacing

If the All-Wheel Drive Control Module -J492- should be replaced, the >>clutch adaptation values<< for the old control module must be read out now using the Vehicle Diagnostic Tester. Refer to ADDITIONAL WORK FOR VEHICLES WITH "quattro ultra" .