Reflector, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- The vehicle and the reflector must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Clean the adhesive surface of the plastic side with Cleaning Solution and let it dry.
-- Apply Primer on the plastic side of the adhesive surface and let dry until the solvent has completely evaporated.
- Apply the reflector within 60 minutes.
-- Remove the protective films from the adhesive tape -1-.
-- Position the reflector -2- and press it onto the bumper cover -3-.
- Resting time approximately 30 minutes at room temperature