Bumper Cover, Adjusting: Notes
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- Depending on the equipment version, the following additional work must be performed. Refer to Depending on the version, the following additional work is required: .
Procedure
-- Loosen bolts -1 and 2-.
-- Adjust the front bumper cover lengthwise according to the markings -arrow-.
-- Tighten the bolts.
-- Check the gap dimension for evenness, and repeat the adjustment if necessary.