Brake Pads, Removing And Installing, Six-Piston Ceramic Brake: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the brake caliper. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, SIX-PISTON CERAMIC BRAKE .

-- Remove the brake pad wear sensor. Refer to BRAKE PAD WEAR INDICATOR WIRE, REMOVING AND INSTALLING .

-- If the brake pads are being replaced, place the Piston Resetting Tool:T10145 with a wooden block -1- placed between it and the old brake pads and push the brake caliper pistons all the way back into the brake caliper.

Courtesy of AUDI OF AMERICA, LLC

TIP:

Label the brake pads when removing if they are going to be used again. Install in the same position, otherwise the braking effect will be uneven.

-- Remove the brake pads -1 and 2- in succession from the guide pins -arrows-.

Fig 1: Identifying Brake Pads And Guide Pins

Courtesy of AUDI OF AMERICA, LLC

-- If the brakes pads are replaced, then the brake pad springs must also be replaced. To do this, pry the brake pad springs -1 and 2- out of the brake caliper with a screwdriver -arrows-.

Fig 2: Identifying Brake Pad Springs

Courtesy of AUDI OF AMERICA, LLC