Vehicle Diagnosis, Closing And Sending The Diagnostic Log

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Perform the test programs according to the test plan.

-- Switch to the control modules tab.

-- Press the X Diagnosis button and end the diagnosis.

-- Send the diagnostic log online.

NOTE:

Deleting the DTC memory takes place when exiting the Guided Fault Finding,

Sending the diagnostic log takes place when exiting the Guided Fault Finding ,

If there is no network connection available, the diagnostic log is temporarily saved a few days. The online transfer should then take place as soon as possible.