Readiness To Send And Receive: Activating

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The Full pre-delivery inspection test program may also be performed as part of the pre-delivery inspection.

Procedure :

-- Connect the Vehicle Diagnostic Tester.

-- Select Diagnostics mode.

-- Deselect "Working with Guided Fault Finding" by removing v and pressing Accept .

-- Start the diagnostic

-- Perform the vehicle identification.

-- Change to the "Special functions" tab and select the following program under the headline "Delivery service" :

Readiness to Send and Receive: Activating

-- Start the program using Perform test... .

-- Continue the program sequence.

CAUTION:

Readiness to send and receive is required to use the emergency call function. Vehicles without activated readiness to send and receive must not be handed over to the customer.