Telephone BASEPLATE, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

The Telephone Baseplate -R126- / the Mobile Device Charger 1 -J1146- -1- is installed in the multimedia device storage compartment.

Courtesy of AUDI OF AMERICA, LLC

The rubber lip on the surface on which the :T40388 was inserted must be slightly pressed out.

-- Using the :T40388 -A-, arefully push the rubber lip at the front of the Mobile Device Charger 1 -J1146- to the side and guide in the :T40388 vertically from above as shown.

-- The catch -2- is released and engages in the groove on the :T40388 -A-.

-- Pull the :T40388 -A- back out vertically upward and remove the Mobile Device Charger 1 -J1146- -1- from the storage compartment.

-- The Mobile Device Charger 1 -J1146- is clipped in on the opposite side. Pivot the Mobile Device Charger 1 -J1146- -1- out of the storage compartment.

-- Release and disconnect the connectors from the Mobile Device Charger 1 -J1146-.