Calibration Requirements on Vehicle

• Camera lens must be cleaned, only clean the camera lenses with a wet towel.
• Check the camera images on the Front Information Display Control Head -J685-.Replace the camera if the images are unclear because the camera has been damaged. Check the fastener for the camera if the image is low.
• Make sure both exterior rearview mirrors are folded out.
• The parking brake must be set.
• The steering wheel must be in the 0 position and the wheels must be straight.
• All doors, the rear lid must be closed.
• There are no people in the vehicle.
• The vehicle is not loaded (curb weight).
• The battery charger is connected, the battery charger must not be in the view of the camera.
• Ignition switched on.
• The system is active and is displayed on the Front Information Display Control Head -J685-.
• Do not move the vehicle during the calibration process.

Requirements for Calibration Equipment/Calibration Environment

• flat calibration surface
• Do not use any objects in the environment of the calibration field, to prevent a false recognition of lines
• Even light (no headlamps or direct illumination), prevent strong light differences