Headliner, Lowering For Roof Antenna Removal
The procedure description refers to the A4 Avant.
Special tools and workshop equipment required
- Pry Lever :80-200
- Removal Wedge :T40233
Procedure
Risk of injury due to involuntary deployment.
- Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
-- Move the rear headrests into the lowest position.
-- Detach the B-pillar upper trim panels (refer to B-PILLAR UPPER TRIM PANEL, REMOVING AND INSTALLING ) and move to the side with the seat belt.
-- Remove the C-pillar trim panels. Refer to C-PILLAR TRIM PANEL, REMOVING AND INSTALLING, AVANT .
-- Remove the luggage compartment side trim panels. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING, AVANT .
-- Remove the roof end strip. Refer to ROOF END STRIP, REMOVING AND INSTALLING .
-- Remove the D-pillar trim panels. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING, AVANT .
-- Remove the roof grab handle. Refer to ROOF GRAB HANDLE, REMOVING AND INSTALLING .
Versions equipped with a Sliding Sunroof:
-- Open the sun shade.
-- To avoid getting dirt on the headliner, clean the Removal Wedge :T40233 .
-- Push the Removal Wedge :T40233 between the sunroof frame -1- and the headliner.
-- Using the Removal Wedge :T40233 , loosen the headliner all the way around the sunroof frame -arrows-.
Continuation for All Vehicles:
-- Free up the headliner in the area near the inner door seals.
-- Unclip the headliner -1- with the trim -2- and bracket from the screen separator mounting eye -arrow-.
-- Repeat the procedure on the opposite side.
- The headliner bends easily.
- Replace the headliner if it is bent.
-- Grip under the headliner by hand and unclip from the body at the rear of the centering pin -1- -arrow-.
-- Lower the headliner.
-- Remove the roof antenna. Refer to ROOF ANTENNA, REMOVING AND INSTALLING .
Assembling
-- Align the headliner, press in the centering pins and clips at the back of the headliner until it engages audibly in the body mounting point.
-- Stretch over the lip of the rear lid and inner door seals.
Versions equipped with a Sliding Sunroof:
-- Clip the sides of the headliner into the sunroof frame first, and then into the front and rear.
Further assembly is performed in reverse order.