Overview - Front Door Trim Panel
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- Pull Handle with Armrest
- Equipped on some models:
- Driver Door Storage Compartment Illumination Bulb -L160-
- Front Passenger Door Storage Compartment Illumination Bulb -L161-
- Component Location Overview. Refer to COMPONENT LOCATION OVERVIEW - FRONT DOOR LAMPS .
- Removing and installing. Refer to FRONT PULL HANDLE, REMOVING AND INSTALLING .
- Equipped on some models:
- Switch Mount
- Removing and installing. Refer to FRONT PULL HANDLE, REMOVING AND INSTALLING .
- Bolt
- For door trim panel
- Quantity: 3
- 2.5 Nm
- Entry Lamp
- Driver Side Entry Lamp -W92-
- Passenger Side Entry Lamp -W93-
- Component Location Overview. Refer to COMPONENT LOCATION OVERVIEW - FRONT DOOR LAMPS .
- Rear Reflector
- Equipped on some models:
- Driver Exit Warning Lamp -W111-
- Front Passenger Exit Warning Lamp -W112-
- Component Location Overview. Refer to COMPONENT LOCATION OVERVIEW - FRONT DOOR LAMPS .
- Equipped on some models:
- Interior Monitoring and Vehicle Inclination Deactivation Button -E616-
- Component Location Overview. Refer to COMPONENT LOCATION OVERVIEW - CONTROLS IN FRONT DOORS .
- Bolt
- For the armrest
- Quantity: 15
- 1.2 Nm
- Clip
- For door trim panel
- Quantity: 8
- Insert in the trim panel
- Bolt
- 4 Nm
- Clip
- For door trim panel
- Bolt
- For the interior door mechanism
- Quantity: 4
- 1.2 Nm
- Window Frame Trim Panel
- Removing and installing. Refer to WINDOW FRAME TRIM PANEL, REMOVING AND INSTALLING .
- Door Trim Panel Stopper
- 4.5 Nm
- Central Locking -Safe- Indicator Lamp -K133-
- Driver door only
- Sleeve
- For the Central Locking -SAFE- Indicator Lamp -K133-
- Driver door only
- When replacing the door trim panel, a hole for the sleeve must be made in the new panel by using the old panel as a model
- Door Trim Panel
- Removing and installing. Refer to FRONT DOOR TRIM PANEL, REMOVING AND INSTALLING .
- When replacing the door trim panel, a hole for the sleeve ) OVERVIEW - FRONT DOOR TRIM PANEL must be made in the new panel by using the old panel as a model
- Interior Door Mechanism
- Removing and installing. Refer to INTERIOR DOOR MECHANISM, REMOVING AND INSTALLING .
- Interior Door Mechanism Decorative Trim
- Removing and installing. Refer to INTERIOR DOOR MECHANISM, REMOVING AND INSTALLING .
- Decorative Trim
- Removing and installing. Refer to FRONT DOOR TRIM PANEL, REMOVING AND INSTALLING .
- Rear Lid Remote Release Button -E233-
- Component Location Overview. Refer to COMPONENT LOCATION OVERVIEW - CONTROLS IN FRONT DOORS .
- Speaker Trim
- For the bass speaker
- Removing and installing. Refer to SPEAKER TRIM IN DOOR TRIM PANELS, REMOVING AND INSTALLING .
- Engage in the door trim panel and press on it until it engages audibly
- Door Pocket Trim
- Insert into the door