Replacing Tool Head

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Select the appropriate tool head based on the antenna wire test. Refer to Checking the Antenna Wire .

-- Open the handle on the pliers all the way.

-- Release and remove both locking pins in direction of -arrows- from the handle.

Fig 1: Disengaging Crimping Tool Locking Pins

Courtesy of AUDI OF AMERICA, LLC

-- Attach the necessary tool head to the handle from the top in direction of -arrow-.

Fig 2: Identifying Insertion Of Crimping Tool Head

Courtesy of AUDI OF AMERICA, LLC

-- Insert the pins in direction of -arrows- into the handle in order to lock the tool head into place.

Fig 3: Engaging Crimping Tool Locking Pins

Courtesy of AUDI OF AMERICA, LLC