Oil Pan Upper Section, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi A3 Quattro and 2024 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

The transmission is removed. Refer to TRANSMISSION, REMOVING AND INSTALLING .

-- Remove the transmission side sealing flange. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .

-- Remove the oil pump -2-. Refer to OIL PUMP, REMOVING AND INSTALLING .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front air duct pipe and leave it in the installation position. Refer to FRONT AIR DUCT PIPE, REMOVING AND INSTALLING .

-- Remove the Fastening Device:T40414 and bring the drive chain tensioning rail -1- to resting position.

-- Disconnect the connector -1- for the Oil Pressure Regulation Valve -N428-.

Fig 1: Identifying Oil Pressure Regulation Valve

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

Fig 2: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Position the plugs on the bolt -14-.

Fig 3: Identifying Oil Pan Upper Section Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 to 18- and loosen the oil pan upper section from the bonding.

First pry the oil pan upper section out on the transmission side. When prying out proceed carefully - risk of damaging the timing chain cover.