Turbocharger, Removing And Installing: Notes

WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.

If mechanical damage (for example a destroyed compression wheel) is found on the turbocharger, just replacing the turbocharger is not enough. To avoid subsequent damage later, perform the following steps:

Check the air filter housing, air filter element and air duct hoses for contamination.
Check the entire charge air circuit and charge air cooler for foreign objects.
If there are foreign objects in the charge air system, clean the charge air circuit and replace the charge air cooler if necessary.

Special tools and workshop equipment required

Engine Bung Set :VAS 6122

Fig 1: Engine Bung Set
Courtesy of AUDI OF AMERICA, LLC
Hose Clip Pliers :VAS 6340

Fig 2: Hose Clip Pliers VAS6340
Courtesy of AUDI OF AMERICA, LLC
Hose Clip Pliers :VAS 6362

Fig 3: Hose Clip Pliers
Courtesy of AUDI OF AMERICA, LLC
Socket :T10405

Fig 4: Identifying Socket T30
Courtesy of AUDI OF AMERICA, LLC
Bit Torx T30 :T10573

Fig 5: Bit Torx T30 T10573
Courtesy of AUDI OF AMERICA, LLC