Turbocharger, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Follow the tightening sequence exactly ) Part 1
- Replace bolts that were tightened with an additional turn after removing them.
- Coat the turbocharger stud bolts with hot bolt past. Refer to the Parts Information.
- Fill the turbocharger with engine oil at the oil supply line connection.
- Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
- After installing the turbocharger, let the engine idle for approximately one minute without increasing the engine speed. This ensures adequate oil supply to the turbocharger.
- Used coolant cannot be used again.
-- Install the catalytic converter. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .
-- Install the Oxygen Sensor 1 Before Catalytic Converter -GX10-. Refer to HEATED OXYGEN SENSOR, REMOVING AND INSTALLING .
-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Check the oil level. Refer to ENGINE OIL .
-- Fill the coolant. Refer to COOLANT, DRAINING AND FILLING .