Camshaft Adjustment Valve 1 -N205- /Exhaust Camshaft Adjustment Valve 1 -N318-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Replace the O-ring after removal.

-- Clean a used valve for the camshaft adjustment as well as the mount in the cylinder head of contamination.

-- Coat the O-ring with engine oil.

TIP:

Also after tightening the bolts the valves can be lightly turned back and forth for the camshaft adjustment due to the vibration decoupling.

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

After removing or replacing the camshaft adjustment valve 1 the adaptation values for the chain length must be adapted again.

-- Connect the Vehicle Diagnostic Tester.

-- Select Diagnostic operating mode and Start diagnostics .

-- Select the Select individual test tab and select the following tree structure consecutively:

Drive (display depends on the model)
Select the engine code and engine (display depends on the model)
0001 - OBD-Capable Systems or Diagnostic-Capable System
0001 - Engine Electronics
0001 - Engine electronics, functions
0001 - Adaptation diagnostic chain length