Camshaft Timing Chain, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Place the camshaft timing chain -2- on the drive chain sprocket -1- and tie it up.
-- Install the lower timing chain cover. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .
-- Install the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
After removing or replacing the chain drive components the adaptation values for the chain length must be adapted again.
-- Connect the Vehicle Diagnostic Tester.
-- Select Diagnostic operating mode and Start diagnostics .
-- Select the Select individual test tab and select the following tree structure consecutively:
- Drive (display depends on the model)
- Select the engine code and engine (display depends on the model)
- 0001 - OBD-Capable Systems or Diagnostic-Capable System
- 0001 - Engine Electronics
- 0001 - Engine electronics, functions
- 0001 - Adaptation diagnostic chain length