Vacuum Pump, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace the seal.
-- Make sure the seal is in the correct installation position.
-- Turn the vacuum pump yoke -1- so that it engages in the grooves on the drive chain sprocket for the camshaft timing chain when positioning the vacuum pump -arrows-.
-- Install the left coolant pipe. Refer to COOLANT PIPES, REMOVING AND INSTALLING .
-- Install the starter. Refer to STARTER, REMOVING AND INSTALLING .