Overview - Belt Pulley Side Sealing Flange
WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Tightening Specification. Refer to ) OVERVIEW - RIBBED BELT DRIVE.
- Washer
- Vibration Damper
- The illustration does not show the version in the vehicle.
- Overview. Refer to OVERVIEW - RIBBED BELT DRIVE .
- Only possible to install in one position.
- Sealing Flange, Belt Pulley Side
- With centering bushing
- Replace after removing
- Install with sealant. Refer to the => Parts Information.
- Removing and Installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
Ribbed belt pulley side sealing flange - tightening specifications and sequence
- Replace bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts -arrow- in steps:
| Step | Tightening Specification |
|---|---|
| 1. | Install all the way by hand |
| 2. | 3 Nm in a diagonal sequence |
| 3. | 45° diagonal sequence |