Left Vent Temperature Sensor -G150-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

An incorrectly installed vent temperature sensor causes flow-generated noise.

-- Replace the seal -3- if it is damaged or faulty.

-- Then check the DTC memory and delete any displayed entries using the Vehicle Diagnostic Tester .