Right Seal, Replacing, Fwd Vehicles: Removing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

The transmission is installed.

-- Remove the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Grease the drill bit -3- so that the shavings stick to it.

CAUTION:

Risk of damaging the bearing when drilling.

- Only drill through the metal ring of the shaft seal.

- Do not install the screw too deep.

-- Seal the opening on the transmission for the drive axle with a clean cloth -2-.

-- Carefully drill a 2 to 4 mm hole into the outer metal ring -1- of the seal.

-- Place the Used Oil Collection and Extraction Unit:SMN372500 under the transmission.

-- Install a bolt (approximately 4 mm diameter) into the drilled out hole on the seal.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the seal using the Puller - Unit Injector:T10055 and the Adapter:T10055/2 .

-- Carefully remove the cloth. Make sure that no shavings get into the transmission when doing so.

-- Carefully clean the transmission and the opening for the drive axle.