Right Flange Shaft, Removing And Installing, Vehicles With AWD: Removing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is installed.
-- Remove the nuts -arrows- and remove the right drive axle heat shield.
-- Remove the right drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
-- Place the Used Oil Collection and Extraction Unit:SMN372500 under the transmission.
-- Remove the flange shaft bolt using the Socket and Extended Bit:T10107A by installing two bolts in the flange and counterholding the flange shaft with an assembly lever -1-.
-- Fasten the Puller - Flanged Shaft:T10037 to the right flange shaft as shown.
-- Align the Puller - Flanged Shaft with the Knurled Nut:T10037/1 and the spindle -A- so that it is parallel to the flange.
-- Remove the flange shaft.