Output Flange, Removing And Installing, 0FN: Installing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Apply the O-ring -arrow- on the shaft.
- The O-ring must be located behind the splines in the bottom of the surrounding groove -arrow-.
-- Coat the outer circumference of the new shaft seal -1- with transmission fluid.
-- Use the Seal Installer - Side Shaft:T40121 to drive the seal all the way in.
-- Fill the space between the sealing/dust lip halfway with sealing grease. Refer to the Parts Information.
-- Drive in the output flange -A- carefully using a plastic mallet on the shaft.
-- Install the washer -A-.
-- Secure the output flange using the circlip -B-.
- The circlip -B- has an uneven shape -arrow 1-.
- The circlip -B- must be located in the base of the surrounding groove -arrow 2-.
-- Fill the gear oil. Refer to GEAR OIL, DRAINING AND FILLING .