Transmission Fluid Cooler, Removing And Installing: Installing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace the O-rings -arrows- after removal.
- Coat the O-rings with transmission fluid before inserting to prevent the rings from being crushed during assembly.
- If there is damage to the sealing surface of the transmission fluid cooler it must be replaced.
-- Remove the screen -1- of the oil cooler carefully using a screwdriver and check for contamination.
-- If necessary, clean the screen and clip it in again.
-- Carefully position the transmission fluid cooler -A-. At the same time pay attention to the sealing surface and the O-rings.
-- Position the bolts -arrows- in steps diagonally.
-- Install the battery tray. Refer to BATTERY TRAY, REMOVING AND INSTALLING .
-- Check the transmission fluid level land fill. Refer to TRANSMISSION FLUID LEVEL, CHECKING .
-- Check the coolant level. Refer to COOLANT, DRAINING AND FILLING .