Overview - Assembly Mounts
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- 1 -
Engine Support
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
- 2 -
Bolt
- Tightening specification. Refer to OVERVIEW - ASSEMBLY MOUNTS
- 3 -
Bracket
- Equipped on some models
- 4 -
Bolt
- Tightening specification. Refer to OVERVIEW - ASSEMBLY MOUNTS
- 5 -
Engine Mount
- With support arm
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- 6, 7 -
Bolt
- Tightening specification. Refer to OVERVIEW - ASSEMBLY MOUNTS
- 8 - Ground Wire
- 9 -
Nut
- Tightening Specification. Refer to Wiring Diagram.
- 10 -
Bolt
- Tightening specification. Refer to OVERVIEW - ASSEMBLY MOUNTS
- 11 -
Pendulum Support
- Removing and Installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- 12 -
Bolt
- Replace after removing
- 130 Nm +90°
- 13, 14 -
Bolt
- Replace after removing
- 60 Nm +90°
- 15 -
Bolt
- Replace after removing
- 60 Nm +90°
- 16 -
Transmission Mount
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- 17 -
Bolt
- Replace after removing
- 50 Nm +90°