Windshield Wiper Arm, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Switch the ignition on.

-- Activate "rear wiping" and let the wiper arm run to end position.

-- Switch off the ignition and all electrical equipment. Place the ignition key outside of the vehicle.

-- Carefully expand the cap -arrows- and lift off.

Fig 1: Identifying Cover

Courtesy of AUDI OF AMERICA, LLC

-- Carefully remove the washer nozzle -2-.

Fig 2: Identifying Spray Jets And Hex Head Nuts

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the nut -1- one turn.

-- Install an M6 nut -4- on the nut.

Fig 3: Position The Puller T10369/1 On The Wiper Arm

Courtesy of AUDI OF AMERICA, LLC

-- Position the Puller - Wiper Arm Kit - Puller 1:T10369/1 on the windshield wiper arm -1- as shown.

-- Position the thrust piece -2- on the windshield wiper axle.

-- Turn the bolt -3- clockwise until the windshield wiper arm is removed from the windshield wiper axle.

-- Remove the nut completely and remove the wiper arm.