Leak Test
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
High Pressure Test:
- Brake system (brake master cylinder, brake hoses, brake lines and brake calipers) tested for function and leaks.
-- Remove the bleed screw at one of the front brake calipers. Connect the Brake Pressure Gauge:V.A.G 1310 A and bleed.
-- Insert the Brake Pedal Actuator:V.A.G 1869/2 -item A- between the brake pedal and driver seat. Apply pressure to the brake pedal until the pressure gauge indicates a pressure of 50 bar (725.19 psi).
- The pressure must not drop more than 4 bar (58.02 psi) during the test period of 45 seconds.
- Replace the brake master cylinder if the pressure decrease is too high.
Low pressure testing:
-- Set the brake pedal actuator back far enough that the pressure gauge indicates 6 bar (87.02 psi) positive pressure.
- The pressure must not drop by more than 1 bar (14.5 psi) during a test period of 3 minutes.
- Replace the brake master cylinder if the pressure decrease is too high.