Right LED Headlamp Power Output Module 1 -A27- / Left LED Headlamp Power Output Module 1 -A31-, REMOVING AND INSTALLING: Notes
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Safety Gloves
- Protective Eyewear
- Cutter, commercially available
-- If replacing the control module, select the "Replace control module" function for the corresponding control module .
TIP:
To replace the power output module the headlamp housing must be cut open at the designated area using a sharp cutter.
A housing cover can be ordered to seal the installation opening. Refer to the Electronic Parts Information (ETKA).