Alcohol Interlock System, Removal
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Pay attention to the manufacturer instructions.
Removing
-- Connect the Vehicle Diagnostic Tester.
-- Select "flash".
-- Select "Enter SVM code".
-- Perform the software update with SVM code -46A610-.
-- Switch off the ignition.
-- Remove the fuse 10 A in the fuse panel single fuse at the Fuse Panel C -SC- in the left front of the footwell.
-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .
-- Remove the alcohol interlock system control module and handheld from the glove compartment.
-- Remove the wires from the glove compartment, secure them to the bulkhead and insulate them.
-- Remove the grommet, close holes in the glove compartment with fitting plugs.
-- Install the glove compartment.