Valve, Removing And Installing, Rubber Valve
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure wheel rim is clean.
-- Using the Valve Fitting Tool:VAS6459 -1-, insert a new tire valve.
-- Remove the valve insert.
-- Inflate the tire to approximately 3 to 4 bar (43.51 to 58.02 psi); the tire bead must slip audibly over the rim hump when doing this.
-- Install the valve insert.
-- Fill the tire to the specified pressure.
CAUTION:
Do not screw any aluminum valve caps onto steel valve bodies. Aluminum caps attach to the steel valve body into a inseparable connection and cannot be separated again.
-- Balance the tire.