Valve, Removing And Installing, Metal Valve: Installing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Only apply the specified torque to tighten the nut for the metal valve.
Tightening more is not permitted because it damages the seal.
-- Tighten the nut -1- of the metal valve.
-- Counterhold -arrow- the metal valve using a retainer (for example 2 mm spiral bore) while doing so.
-- Install the Tire Pressure Monitoring Sensor --.
-- Fill the tire to the specified pressure.
CAUTION:
Do not screw any aluminum valve caps onto steel valve bodies. Aluminum caps attach to the steel valve body into a inseparable connection and cannot be separated again.