Mounting Bracket Installation Position to Trailing Arm, Adjusting
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Dimension -a- = 37 mm.
- Mounting Bracket
- Trailing Arm
- Place a steel ruler as shown on the mounting bracket and adjust to the dimension given above. Make sure that the steel ruler is resting completely on the mounting bracket and is positioned at the inner edge of the trailing arm.
-- When dimension -a- has been adjusted, tighten the bolt -3-.