Spring, Removing And Installing, Torsion Beam Axle: Installing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Check the spring support for damage and replace them if necessary.
-- Install the spring support on the lower coil spring.
- The spring start -arrow- must touch the stop of lower spring support.
-- Install the spring and the spring support.
-- Insert the pin of the lower spring support in the hole of the lower spring mount on the axle beam.
-- Insert the top of the spring support into the upper spring end.
- The bead on the spring support -arrow- must fit into the coil spring correctly.
-- Release the tension on the spring, guiding upper spring support onto tab of body.
-- Remove the Spring Compressor.
-- Press in the locking ring -1- in the reverse in direction of -arrow- until stop.
-- Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .