Spring, Removing And Installing, Multi-Link Suspension: Removing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the wheel. Refer to WHEELS AND TIRES .
-- If equipped, remove the transverse link stone chip protection. Refer to TRANSVERSE LINK STONE CHIP PROTECTION, REMOVING AND INSTALLING .
-- Push the tab -arrow- inward and remove the assembly aid -1- outward.
-- Insert the spring tensioner -3-.
- Spring Compressor Kit - Spring Retainer with Inserts:VAG1752/3A for FWD vehicles or Spring Compressor Kit - Spring Retainers:VAG1752/21 for AWD vehicles
- Spring Compressor Kit - Adapter Blocks:VAG1752/9
- Spring Compressor Kit - Spring Tensioner:VAG1752/1
- Spring
CAUTION:
There is a risk of injury if the coil spring pops out suddenly.
It is possible that parts of the body may become bruised.
- Note the instructions that follow.
- Make sure that the coil spring is seated correctly -arrow- in the Spring Compressor Kit - Spring Retainer with Inserts:VAG1752/3A .
-- Tension the coil spring until it can be removed.
TIP:
Use a wrench or a reversible ratchet to tighten the spring compressor.