Front Bonded Rubber Bushing, Replacing: Notes

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Hydraulic Press:VAS6178

Courtesy of AUDI OF AMERICA, LLC
Pneumatic/Hydraulic Foot Pump:VAS6179

Courtesy of AUDI OF AMERICA, LLC
Bearing Installer - Wheel Hub/Bearing Kit :T10205A

Courtesy of AUDI OF AMERICA, LLC
Hydraulic Press - Rear Subframe Bushing Tool Kit:T10263

Courtesy of AUDI OF AMERICA, LLC
Assembly Tool:T10356A

Courtesy of AUDI OF AMERICA, LLC
Assembly paste. Refer to the => Electronic Parts Information (ETKA).

If a bonded rubber bushing is faulty, then the bonded rubber bushing on the opposite side must also be replaced. Refer to the => Electronic Parts Information (ETKA) for the allocation.
Check the other bearing before switching out a defected bonded rubber bushing.
If there are any tears or other visible damages, also replace the bonded rubber bushing.
Before removing the bonded rubber bushing mark the installation position to the subframe with a felt-tip pen.