Overview - Transverse Link
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Washer
- Nut
- Replace after removing
- Upper Transverse Link
- Removing and Installing. Refer to UPPER TRANSVERSE LINK, REMOVING AND INSTALLING .
- Washer
- Installed depending on vehicle equipment. Refer to the => Electronic Parts Information (ETKA).
- Bolt
- 130 Nm + 180°
- Replace after removing
- Tighten the threaded connections in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Wheel Bearing Housing
- Nut
- Replace after removing
- Expanding Rivets
- Bolt
- 70 Nm + 180°
- Replace after removing
- Tighten the threaded connections in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Lower Transverse Link
- Removing and Installing. Refer to LOWER TRANSVERSE LINK, REMOVING AND INSTALLING .
- Stone Chip Protection
- Installed depending on vehicle equipment. Refer to the => Electronic Parts Information (ETKA).
- Bolts
- Tightening Specification. Refer to -item 3- OVERVIEW - SUBFRAME ATTACHMENT => List Item:Bolt.
- Subframe
- Eccentric Screw
- Perform a vehicle alignment after loosening. Refer to AXLE ALIGNMENT .
- The maximum adjustment range is 90° to left or right of center position.
- Nut
- 95 Nm
- Replace after removing
- Tighten the threaded connections in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Eccentric Washer
- Inner hole with tab
- Eccentric Screw
- Perform a vehicle alignment after loosening. Refer to AXLE ALIGNMENT .
- The maximum adjustment range is 90° to left or right of center position.
- Eccentric Washer
- Inner hole with tab
- Nut
- Tightening Specifications
- Without Insert Tool - 18mm:T10179 95 Nm
- With Insert Tool - 18mm:T10179 80 Nm
- Replace after removing
- Tighten the threaded connections in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Tightening Specifications