Steering Gear, Removing And Installing: Installing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Attach the steering gear -1- to the subframe.
- The steering gear threaded sleeves -2- must be inserted into the subframe holes -arrow-.
-- Position the steering gear bolts.
- Make sure they are not damaged and the seal is not twisted.
-- Install the subframe with the steering gear. Refer to SUBFRAME WITH STEERING GEAR, REMOVING AND INSTALLING .
- If the steering gear is replaced, the Power Steering Control Module -J500- must be activated to do so select the "replacing" function in the "Guided Functions" . Using the Vehicle Diagnostic Tester.
- After installing the old or a new steering gear perform the basic setting for the Steering Angle Sensor -G85-, use the Vehicle Diagnostic Tester Refer to Steering Angle Sensor -G85- BASIC SETTING .
-- Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .