Drive Axle, Disassembling And Assembling, Outer CV Joint, All

Special tools and workshop equipment required 

• Slide Hammer Set:VW771 

  Courtesy of AUDI OF AMERICA, LLC

• Puller - Drive Axle:T10382 

  Courtesy of AUDI OF AMERICA, LLC

Remove the outer CV joint

Courtesy of AUDI OF AMERICA, LLC

-- Clamp the drive axle horizontally in a vise with protective covers.

-- Fold back the protective joint boot.

-- Align the Puller - Driveshaft:T10382  so that the flat side of the Puller - Driveshaft - Removing Plate:T10382/1  faces the Puller - Driveshaft - Spindles:T10382/2  .

-- Attach the Puller - Driveshaft:T10382  to the Slide Hammer Set:VW771  .

-- Remove the CV joint from the drive axle using the puller and slide hammer set.

1. Puller - Drive Axle - Removing Plate:T10382/1 
2. Puller - Drive Axle - Spindles:T10382/2 

Outer CV Joint, Installing

Courtesy of AUDI OF AMERICA, LLC

-- Pay attention to the installation position for versions with plate spring -1- and thrust ring -2-.

-- Install the new circlips.

-- Slide the new CV boot onto the drive axle if necessary.

-- CV joint onto the shaft with a plastic hammer until the circlip engages.