Axle Alignment Test Requirements
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Follow the general information regarding vehicle alignment. Refer to AXLE ALIGNMENT INFORMATION .
- Before driving the vehicle onto the alignment rack, make sure there is enough space between the vehicle and the setting device. Distance between the setting device and the vehicle: 120 cm ± 2.5 cm.
- If there is not enough space, drive the vehicle backward on the alignment rack to be able to use the space.
- Vehicle must be cool.
- Check suspension, steering and steering linkage for excessive play and damage, repair if necessary.
- Tread depth difference may be no more than 2 mm on an axle.
- Prescribed tire pressure
- Make sure that the sliding plates and turn tables are not touching the end stop when checking the wheel alignment.
- The measurement sensor must be properly adjusted and attached to the vehicle; observe device manufacturer's operating instructions.
- The alignment rack and wheel alignment computer can deviate from their original calibration over time; therefore, they should be calibrated at least once a year during maintenance.
- Handle highly sensitive units with care.
- If necessary, contact the manufacturer for instruction on the proper use of the equipment.