Axle Alignment Specified Values, Torsion Beam Rear Axle
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- The specified adjustment values correspond to the curb weight position. Refer to Dimension Overview . To determine the curb weight position, the dimension -a- between the center of the wheel and the lower edge of the fender/wheel housing must be determined.
- Specified values valid for all engine versions.
- Production Control Number (PR number) explanation. Refer to PRODUCTION CONTROL NUMBER (PR NUMBER) EXPLANATIONS .
| Torsion Beam Axle | A3 Standard Suspension 1JA/G07 | A3 Sport Suspension 1JC/G08 | A3 Heavy Duty Suspension UC7/G09 | |
|---|---|---|---|---|
| Camber | - 1° ± 10' | - 1° ± 10' | - 1° ± 10' | |
| Maximum permissible difference between both sides | 30' | 30' | 30' | |
| Total toe, wheels not pressed | 20' ± 12' | 24' ± 12' | 16' ± 12' | |
| Maximum permissible deviation in direction of travel relative to vehicle longitudinal axis | 12' | 20' | 20' | |