Axle Alignment Specified Values, Multi-Link Rear Axle

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

The specified adjustment values correspond to the curb weight position. Refer to Dimension Overview . To determine the curb weight position, the dimension -a- between the center of the wheel and the lower edge of the fender/wheel housing must be determined.

Fig 1: Determining Height Dimension -a-
Courtesy of AUDI OF AMERICA, LLC
Specified values valid for all engine versions.
Production Control Number (PR number) explanation. Refer to PRODUCTION CONTROL NUMBER (PR NUMBER) EXPLANATIONS .

Multi-Link Suspension	A3 Standard Suspension 1JA/G01	A3 with High-Voltage System Standard Suspension 1JA/G11	A3 Sport Suspension 1JC/G02/G12
Camber	- 1° 20' ± 30'	-1° 45' ± 30'	- 1° 20' ± 30'
Maximum permissible difference between both sides	30'	30'	30'
Total toe, wheels not pressed	26' ± 12'	16' ± 10'	26' ± 12'
Maximum permissible deviation in direction of travel relative to vehicle longitudinal axis	12'	12'	12'

Multi-Link Suspension	A3 Suspension with Electronic Damping 1JP/G04	A3 Heavy Duty Suspension UC7/G03	S3 Suspension 1JE/G05
Camber	- 1° 20' ± 30'	- 1° 20' ± 30'	- 1° 20' ± 30'
Maximum permissible difference between both sides	30'	30'	30'
Total toe, wheels not pressed	26' ± 12'	26' ± 12'	14' ± 10'
Maximum permissible deviation in direction of travel relative to vehicle longitudinal axis	12'	12'	12'

Multi-Link Suspension	S3 Suspension with Electronic Damping UB1/G06	RS3 Suspension 1JR/G15	RS3 Suspension with Electronic Damping UB9/G14
Camber	- 1° 20' ± 30'	-1° 45' ± 30'	-1° 45' ± 30'
Maximum permissible difference between both sides	30'	30'	30'
Total toe, wheels not pressed	14' ± 10'	14' ± 10'	14' ± 10'
Maximum permissible deviation in direction of travel relative to vehicle longitudinal axis	12'	12'	12'