New Connecting Rod, Separating
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
A new connecting rod might not be separated all the way at the predetermined breaking point. If the connecting rod bearing cap cannot be removed by hand, proceed as follows:
-- Mark the cylinder where the connecting rod is allocated to OVERVIEW - PISTONS AND CONNECTING ROD.
-- Tension the connecting rod -1- under the dotted line in a vise equipped with aluminum protective pads.
- Clamp the connecting rod lightly to prevent damaging it.
-- Loosen both bolts -2- approximately five turns.
-- Carefully tap the connecting rod bearing cap -1- with a plastic hammer in the -direction of the arrow- until it comes loose.