Overview - Cylinder Block, Transmission Side: Notes
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Intermediate Plate
- Be careful not to damage or bend when installing
- Removing and Installing. Refer to Figure.
- Alignment Sleeves
- Transmission Side Sealing Flange
- With gasket
- Replace after removing
- Removing and Installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Before installing, remove oil residue from crankshaft journal with a clean cloth
- The guide sleeve may only be removed after the sealing flange has been slid onto the crankshaft journal.
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Intermediate Plate
- Installed, depending on the version
- Removing and Installing. Refer to Fig 2.
- Bolt
- 25 Nm
- Flywheel
- Removing and Installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- Only possible to install in one position
- Bolt
- Replace after removing
- 60 Nm +90°
Intermediate plate, removing and installing