Ribbed Belt, Removing And Installing, Vehicle With Generator: Installing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Install the ribbed belt. Refer to Figure.
-- Turn the tensioner slightly clockwise -arrow- and remove the Locking Pin:T10060A .
-- Release the tension on the tensioner.
-- Check whether the ribbed belt is routed correctly.
-- Start the engine and check whether the ribbed belt runs correctly.