Balance Shaft, Removing And Installing, Exhaust Side: Installing

Install in the reverse order of removal while noting the following:

• After removing the balance shaft the needle bearing must be replaced.
• The needle bearing rim is colored, a needle bearing rim of the same color must be installed.
• Replace the intermediate sprocket after removal.
• Replace bolts that were tightened with an additional turn after removing them.

-- Slide on the pipe at the same time pay attention to the installation position. Refer to Figure.

-- Push together the needle cage from the new needle bearing until it engages.

-- Check if all rollers are correctly installed in the bearing cage.

-- Grease the bearing and bearing track -arrows- from the exhaust side balance shaft with engine oil.

Courtesy of AUDI OF AMERICA, LLC

-- Turn the balance shaft in the installation position.

• The semi-round ring bearing contact surface must point upward.

-- Insert the exhaust side balance shaft and tighten the bolt -1-.

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Install the balance shaft drive chain. Refer to BALANCE SHAFT DRIVE CHAIN, REMOVING AND INSTALLING .