Engine Mount, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Disconnect the connector -2- for the Engine Coolant Level Sensor -G32-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bracket -3- at the coolant expansion tank.

-- Release the catches -arrows- and remove the coolant expansion tank -1- and move to the side.

Audi A3 from MY 2021:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -1 and 2- and remove the ground cable.

-- If equipped, remove the bolts -arrows- and place the bracket -1- to the side.

Courtesy of AUDI OF AMERICA, LLC

Continuation for All Vehicles:

Courtesy of AUDI OF AMERICA, LLC

-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

-- Remove the bolts -arrows- and engine mount -1-.