Valve Stem Seals, Removing And Installing, Cylinder Head Removed: Installing

Fig 1: Insert The Valve Stem Seal In The 3365

Courtesy of AUDI OF AMERICA, LLC

In order not to damage the valve stem seal -4- during installation, mount the Assembly Tool:T40452 -3- on the valve stem -2-.

-- Lightly oil the valve stem seal sealing lip.

Depending on the version of the valve stem seal, use the Seal Installer - Valve Stem:3365 or Fitting Tool:T40376/1

-- Insert the valve stem seal into the seal installer -5- and carefully press it all the way onto the valve guide -1- over the Assembly Tool:T40452 .

-- Remove the Assembly Tool:T40452 .

If the valve keepers were removed from the assembly cartridge, they must be inserted into the Valve Cotter Tool Kit - Valve Insertion Device:VAS5161/18 first.

Fig 2: Identifying Installation Cartridge VAS 5161/8

Courtesy of AUDI OF AMERICA, LLC

The large diameter of the valve keepers point upward.

-- Press the assembly cartridge from above onto valve retainer inserting tool and valve keepers.

-- Insert the valve spring and the valve spring retainer. Refer to Figure.

-- Attach the Guide Plate:VAS5161/19C back on the cylinder head.

Fig 3: Identifying Valve Cotter Tool Kit - Guide Plate 19c VAS5161/19C

Courtesy of AUDI OF AMERICA, LLC

-- Insert the assembly cartridge into the guide plate.

-- Press the pressure fork down and pull the knurled bolt up while turning left and right. This inserts the valve keepers (example illustration).

-- Release the pressure fork with the knurled bolt still raised.

-- Repeat the procedure on each valve.

Assembling

-- If removed, install the turbocharger. Refer to TURBOCHARGER, REMOVING AND INSTALLING .

-- Install the intake manifold. Refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .