Oil Spray Jets, Removing And Installing

Special tools and workshop equipment required

Socket: T10545

Fig 1: Torx Bit - T40
Courtesy of AUDI OF AMERICA, LLC
Wrench - 21mm:T40263

Fig 2: Identifying Wrench - 21mm
Courtesy of AUDI OF AMERICA, LLC
Adapter:T40314

Fig 3: Adapter T40314
Courtesy of AUDI OF AMERICA, LLC

Removing cylinder "1" through "3" :

The transmission is removed. Refer to appropriate Service Information .

-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

Fig 4: Using T40263 & T40314

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk of damaging the engine by the timing mechanism skipping.

- Only let the engine turn in the direction of engine rotation.

-- Turn the crankshaft at the vibration damper with the Wrench - 21mm: T40263 , Adapter:T40314 and the 24 mm socket in the direction of -arrow- until the corresponding bolt is accessible.

Removing Cylinder "4" :

-- Remove the crankshaft. Refer to CRANKSHAFT, REMOVING AND INSTALLING .

Continued for All Cylinders:

Fig 5: Exploded View Of Oil Spray Jet And Pressure Relief Valve

Courtesy of AUDI OF AMERICA, LLC

-- Remove the pressure relief valve -1- using the Torx Bit - T40:T10545 .

-- Remove the oil spray jet -2- (example illustration).

Installing

Install in the reverse order of removal while noting the following:

Installation Position

Refer to Figure
Refer to Figure

CAUTION:

There is a risk of damaging the oil spray jets through distortions.

- Never bend the oil spray jets.

-- Install the crankshaft. Refer to CRANKSHAFT, REMOVING AND INSTALLING .

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

Tightening Specifications

Refer to OVERVIEW - PISTONS AND CONNECTING ROD
Refer to OVERVIEW - CRANKSHAFT