Overview - Cylinder Block, Transmission Side: Notes

Fig 1: Exploded View Of Cylinder Block, Transmission Side

Courtesy of AUDI OF AMERICA, LLC

1. Intermediate Plate
   • Be careful not to damage or bend when installing
   • Removing and Installing. Refer to Figure.
2. Alignment Sleeves
3. Transmission Side Sealing Flange
   • Replace after removing
   • With gasket
   • Removing and Installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
   • Before installing, remove oil residue from crankshaft journal with a clean cloth
   • The guide sleeve may only be removed after the sealing flange has been slid onto the crankshaft journal.
4. Bolt
   • Tightening specification and sequence. Refer to Figure.
5. Intermediate Plate
   • Installed, depending on the version
   • Removing and Installing. Refer to Fig 2.
6. Bolt
   • 25 Nm
7. Flywheel
   • Removing and Installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
   • Only possible to install in one position
8. Bolt
   • 60 Nm +90°
   • Replace after removing

Intermediate Plate, Removing and Installing

Fig 2: Intermediate Plate, Removing and Installing

Courtesy of AUDI OF AMERICA, LLC