Crankshaft Needle Bearing, Replacing

Special tools and workshop equipment required 

• Bearing Installer - Bearing Press Piece:VW207C 
  Fig 1: Identifying Bearing Installer

  Courtesy of AUDI OF AMERICA, LLC
• Counter Support:VAS251621 
  Fig 2: Counter Support

  Courtesy of AUDI OF AMERICA, LLC
• Internal Puller:VAS251635 

  Courtesy of AUDI OF AMERICA, LLC

Conditions:

• Always replace the needle bearing -arrow- after the engine and dual clutch transmission are separated.
• The front edges of the internal puller must not be broken off.

Needle Bearing, Removing

Courtesy of AUDI OF AMERICA, LLC

-- The internal puller must be positioned behind the needle rim -upper arrow-.

-- Remove the needle bearing -1- using the Internal Puller:VAS251635  -A- and Counter Support:VAS251621  -B- from the crankshaft -2-.

Installing

-- Clean the bearing seat in the crankshaft and apply a thin coat of grease.

-- Drive the needle bearing into the crankshaft up to the installation depth using the Bearing Installer - Bearing Press Piece:VW207C  .

Installation Depth Dimension a = 2.0 mm

• If the needle bearing is unintentionally pushed in to deeply, it must be replaced, because it will be damaged when it is removed again.